- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I have some questions about the behavior of FM3 / FM4.
1. For example, turn on the power and set LVD detection voltage to 3.9V.
If the supply voltage only rises to 3.5 V, does an interrupt occur when the LVD interrupt is enabled?
(When the power supply voltage never exceeds 4V)
2. Is there a simple way to check that the power supply voltage has exceeded the release voltage from the above conditions?
3. After clearing the LVD interrupt request, if the power supply voltage rises above the release voltage, does the interrupt occur again in the low voltage state?
Teach me please
Regards,
Shimamura
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ans. 1) Although the double check is still needed, the answer would be "Yes".
Ans. 2) Unfortunately, there is not a simple way to check if the power supply voltage is getting higher than the release voltage.
One of solution could be to monitor the voltage externally.
Ans. 3) NO. the interrupt occurs only when the voltage drop happens.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ans. 1) Although the double check is still needed, the answer would be "Yes".
Ans. 2) Unfortunately, there is not a simple way to check if the power supply voltage is getting higher than the release voltage.
One of solution could be to monitor the voltage externally.
Ans. 3) NO. the interrupt occurs only when the voltage drop happens.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Regarding Ans.1), confirmed that the interrupt occurs for this case.