- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
We use miniprog3 programmer for uC CY8C22545(ISSP) in our production, but programming time is aprox. 25 sec.
I would like to ask if is possible speed up programming time ( used another programmer, firmware upgrade or...).
PSOC programmer version 3.13.1.1036
Thank you
Solved! Go to Solution.
- Labels:
-
PSoC 1
-
PSoC 1 Device Programming
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I request you to kindly consider Third-Party programmers as MiniProg3 is not meant for production.
Best regards,
Sampath
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I request you to kindly consider Third-Party programmers as MiniProg3 is not meant for production.
Best regards,
Sampath
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I recommend RPM Systems programmers. We've been using them for years. Great support. I even wrote an interface from our GUI to MPManager to automate the programming process. Cypress PSoC Programmer