- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I want to use ezserial_343026-CYBT_343026_EVAL-rom-ram-Wiced-release FW in CYBT-343026-01. Is the hardware design OK for this officail release?
UART3_TX shoud be GPIO3 or P4/p24? Could you give me a confirmation?
BR,
Treacy
Solved! Go to Solution.
- Tags:
- cybt-343026-01
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please have a look at the HCI UART pins of 343026 module ( Pad 16,17,18,20). Refer module datasheet , Table 4 ( https://www.cypress.com/documentation/datasheets/cybt-343026-01-ez-bt-wiced-module )
You may also refer to our EVAL board schematics : https://www.cypress.com/documentation/development-kitsboards/cybt-343026-eval-ez-bt-module-arduino-e...
Thanks,
Anjana
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please have a look at the HCI UART pins of 343026 module ( Pad 16,17,18,20). Refer module datasheet , Table 4 ( https://www.cypress.com/documentation/datasheets/cybt-343026-01-ez-bt-wiced-module )
You may also refer to our EVAL board schematics : https://www.cypress.com/documentation/development-kitsboards/cybt-343026-eval-ez-bt-module-arduino-e...
Thanks,
Anjana