- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
How to change the exposure in FX2LP by using SET command from GUI? (is this only when AEC disable)? what all registers i must change?
Thanks&Regards
Bhavya
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Bhavya,
You can use Vendor command class for the application and send separate commands to the image sensor for changing the exposure settings. Please refer to the KBA- https://www.cypress.com/comment/264656
Best Regards,
Sananya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Bhavya,
Please refer to the previous thread on the same query-https://community.cypress.com/message/193275?et=watches.email.thread#193275
The registers will depend on your connected image sensor, please let us know which one you are using.
Best Regards,
Sananya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello sananya
The previous thread is for FX3, and Im doing for fx2lp. is there any other method without using UVC(),
please let me know. and Im using WVGA image sensor.
Thanks®ard
Bhavya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Bhavya,
You can use Vendor command class for the application and send separate commands to the image sensor for changing the exposure settings. Please refer to the KBA- https://www.cypress.com/comment/264656
Best Regards,
Sananya