- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I read data from an image sensor and in my design, I need to read to the data on the data line one more time after a line end. So I tried to do this, when the line end the state machine jumps in a state where IN_DATA is and then it hops to the next state. However it not read the data line one time, it read its two time and i checkt how long it is in the state. It is in the state for to time periods of the clock and it also do the extra IN_DATA only every second time.
best regards,
Matthias
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Matthias,
Please try unchecking the box(Repeat actions until next transition) as shown in the below figure:
If the problem persists then please share the state machine so that I can take a look at it.
Regards,
Hemanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Matthias,
Please try unchecking the box(Repeat actions until next transition) as shown in the below figure:
If the problem persists then please share the state machine so that I can take a look at it.
Regards,
Hemanth