Anonymous
Not applicable
Sep 09, 2015
03:28 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 09, 2015
03:28 AM
Hello,
I am looking to set my pressure sensor up which talks over I2C with a BCM20737S. Hardware wise i am ok.
I am not familiar with the M0 libraries. How would you go about initializing the I2C? I need to set my SCL clock speed to 400KHz. My slave address is 0x21h. I do not need to write to the pressure sensor, only read. What is the best way to read incoming data?
Any examples that could help?
Regards,
Luke.
Solved! Go to Solution.
Labels
- Labels:
-
I2C
1 Solution
Sep 09, 2015
07:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 09, 2015
07:11 AM
This appears to be a duplicate of this post: Setting up I2C to talk to pressure sensor on the BCM20737s
1 Reply
Sep 09, 2015
07:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 09, 2015
07:11 AM
This appears to be a duplicate of this post: Setting up I2C to talk to pressure sensor on the BCM20737s