- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
As a follow on to this closed discussion: https://community.cypress.com/message/187923
We’ve tried put ferrite beads, but it made the ripples worse, the aurora eye still close. We’ve built a brand new PWB board with CY2304SXI-2, so there is no need to rework, but the aurora eye still close. We are just wondering that why CY2304SXI-2 doesn’t perform like CY7B991V-5JXI, it is because CY2304SXI-2 has more jitter? It that possible you guys can send a technician to our lab for debugging?
This table is the test result for the old PWB board (it needs to rework in order to drop CY2304SXI into CY7B991V-5JXI footprint)
Aurora Eye | Other functions | Input support | |
CY7B991V-5JX | Open | Work | LVTTL |
CY2304SXI-2 | Close | Work | TTL |
CY2304SXI-1 | Close | Work | TTL |
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Quan,
In the schematic, can you may remove “filter for input”: 274-ohms and 180pF. This will slow the edge which can lead to worse jitter.
Another point is output series resistor: 49.9-ohms, we think your trace is ~50ohms, it might cause the over dumped in impedance matching. If possible can we get the scope shot for the output. Can you implement these changes and check once. The drive characteristics are different for CY2304 and ROBO part and hence we need to modify the schematics.
Thanks,
Pradipta.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Quan,
Can you let us know all the requirements for your application. Like can you let us know the jitter requirement for the device for this application.
Can you share with us the schematics for the clock part.
Thanks,
Pradipta.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The output pk to pk jitter requirement for the device(CY2304SXI-2) is less than 400ps, but the measurement at output of CY2304SXI-2 was more than 500ps
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Quan,
In the schematic, can you may remove “filter for input”: 274-ohms and 180pF. This will slow the edge which can lead to worse jitter.
Another point is output series resistor: 49.9-ohms, we think your trace is ~50ohms, it might cause the over dumped in impedance matching. If possible can we get the scope shot for the output. Can you implement these changes and check once. The drive characteristics are different for CY2304 and ROBO part and hence we need to modify the schematics.
Thanks,
Pradipta.