Apr 17, 2019
02:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 17, 2019
02:20 AM
Hello,
i wanted to send .elf file of fx3(boot file) from usb to fx3 by creating manual in channel and send the same file to zynq through spi communication from fx3 (without storing in fx3, just passing .elf file from usb->fx3->zynq ).
is it possible?
how can i do this?what are the modification/logic should i implement regarding this case in both control centre and fx3 firmawre?
thank you.
Solved! Go to Solution.
1 Solution
Apr 17, 2019
07:29 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 17, 2019
07:29 PM
Hello,
Recommend you to refer to the link below.
1 Reply
Apr 17, 2019
07:29 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 17, 2019
07:29 PM
Hello,
Recommend you to refer to the link below.