in cx3 mipi Receiver configuration Description Resource Path Location Type No Resolution found suitable for USB 2.0 Bandwidth. CyCx3USBHSConfigDscr[] is incomplete. Do not connect to USB 2.0 host or add a lower resolution to support USB 2.0 cx3config.cy

[steven]

Description Resource Path Location Type

No Resolution found suitable for USB 2.0 Bandwidth. CyCx3USBHSConfigDscr[] is incomplete. Do not connect to USB 2.0 host or add a lower resolution to support USB 2.0 cx3config.cycx /cx3_Mipi_Mt9p031 Unknown Problem

ｉ have  refer to the link below.

基于CX3的UVC摄像头应用学习笔记-三

[YangyangC_06 · Accepted solution]

If you configure the description as USB 3.0 mode and ensure that CX3 enumerates as USB 3.0 device, you could ignore this notice. It just reminds you that the firmware you will get could not work in USB 2.0 mode.