- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
Once the sample FW is written to the CY4532 kit, the connetione will not be 2 as attached.(USB Type-A to Micro-B) cable connected to J12 on the CY4532 EVK power Bard). Q)How can I return CY4532 to its initial state?I want to return to the same state as attached
Best Regards
Arai
Solved! Go to Solution.
- Labels:
-
ispn:39570:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Arai-san,
Read document and do the settings appropriately as per Kit Guide.
By following Table 4-1 Jumper settings on CY4532, you can see "Devices connected: 2" on EZ PD Configuration Utility.
"Devices connected: 2" means that 2 devices connected to a host computer because CY4532 has CCG3PA and CCG4.
If you are still something unclear, read document at first and try yourself if you have a CY4532 Kit. Then, kindly ask on Community.
Best regards,
Hirotaka Takayama
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Arai-san,
May I know which firmware you programmed to CCG3PA? CYPD3171-24LQXQ_cla or CYPD3171-24LQXQ_pb?
Regards,
Eddie
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Eddie san
Since there are some issue, I programmed CYPD3171-24LQXQ_pb_3_3_0_1882_0_0_0_pb.hex with miniprog3.
Best Regards
Arai
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Arai-san,
If you programmed powerbank firmware, then you should short pin 2 and pin 3 of J2,J3&J4 on the main board.
See details at Chapter 4.1 Programming the CCG3PA Controller on the CY4532 EVK of CY4532 Kit Guide.
Regards,
Eddie
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Arai-san,
Read document and do the settings appropriately as per Kit Guide.
By following Table 4-1 Jumper settings on CY4532, you can see "Devices connected: 2" on EZ PD Configuration Utility.
"Devices connected: 2" means that 2 devices connected to a host computer because CY4532 has CCG3PA and CCG4.
If you are still something unclear, read document at first and try yourself if you have a CY4532 Kit. Then, kindly ask on Community.
Best regards,
Hirotaka Takayama