PSoC 6 M4 core not starting

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
lock attach
Attachments are accessible only for community members.
euggersh
Level 5
Level 5
5 sign-ins First solution authored 50 replies posted

After lots of experience with PSoC 3, 4, 4 BLE, and 5LP, I'm trying to get some experience with the PSoC 6.  I'm using the CY8CPROTO-063-BLE prototyping kit with the CYBLE-416045-02 EZ-BLE module on it.

I started with the CE221773 PSoC 6 Hello World example and that ran without any issues.  I'm now trying to run the CE212736 Fine Me example, with the LEDs removed (because there's no RGB LED on this kit, and I can use the UART to see what's going on).  I'm doing this in PSoC Creator 4.2 with PDL 3.1.0.

If I debug the M0+ core, I can see that it successfully starts the BLE stack and then tries to start the M4 core.  If I debug the M4 core, execution never reaches main().

Anybody know what's going on here?

Thanks.

(Project attached even though it's just the Cypress example with the changes mentioned above)@

0 Likes
1 Solution
ShipingW_81
Moderator
Moderator
Moderator
500 replies posted 250 solutions authored 250 replies posted

You may get some useful info with referring to thread - Debug the CM4 core

View solution in original post

0 Likes
1 Reply
ShipingW_81
Moderator
Moderator
Moderator
500 replies posted 250 solutions authored 250 replies posted

You may get some useful info with referring to thread - Debug the CM4 core

0 Likes