Can not program with in Creator using MiniProg3 on 8 Pin PSoC4

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Doorknob
Level 4
Level 4
First solution authored 50 replies posted 25 replies posted

I can not seem to get a board of mine with an  8 pin PSoC4 device (CY8C4013SXI-400T) to program using a MiniProg3.  I set up Creator with the following set up, it does see the MiniProg3 but fails to acquire the device.

Thanks

Scott

pastedImage_0.png

0 Likes
1 Solution

Ekta,

I found my issue … I had a part pined out worn which was causing my issues.

Scott

View solution in original post

0 Likes
2 Replies
Ekta_N
Moderator
Moderator
Moderator
750 replies posted First like given 250 solutions authored

Hello Scott,

Can you send the screenshot of the error you are getting. You can try programming the device using PSoC Programmer.

Please have a look at the Programming and debugging section (page 10) of the Hardware Design Consideration application note: https://www.cypress.com/file/141176/download.

Regards,

Ekta

0 Likes

Ekta,

I found my issue … I had a part pined out worn which was causing my issues.

Scott

0 Likes