- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello i have CYPD3171 board i bought mini prog3 last week and i connected it to the pc in the PSOC3 when i read from device it can detect the device CYPD3171 but in EZ-PD CONFIGURATION UTILITY it doesn't detect any device.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
EZ-PD CONFIGURATION UTILITY only can detect CCG3PA device via CC (Type-C port). Please kindly make sure CCG3PA on your end is connecting like below:
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
EZ-PD CONFIGURATION UTILITY only can detect CCG3PA device via CC (Type-C port). Please kindly make sure CCG3PA on your end is connecting like below:
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
that mean EZ-PD configuration Utility doesn't work with miniprog3 ?
can it work with miniprog4 ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
EZ-PD configuration Utility doesn't work with either miniprog3 or miniprog4 . It is difference programming way. Either miniprog3 or miniprog4 is supporting SWD programming. EZ-PD configuration Utility is supporting CC bootloadering on CCG3PA device.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
sorry for long delay, so what proprammer does support EZ-PD configurations utility ??
in pictures it seems like it is the developements kit can it be used for production programming ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
You are correct. The KIT is CCG3PA -- Power board.
Best Regards,
Lisa