- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In my project, I have clocked the MAX11201 ADC via CYBLE-012011-00 I/O pin, but without using the CPU, is there any way to do that, i tried the PWM but dont know why i am not getting the pwm signal at the output pin (port 3 pin 7).
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Abhishekpandey,
There shouldn't be any problem with routing the PWM signal to the pin 3.7. Are you getting any routing error in PSoC Creator? Is the project building successfully?
Even the datasheet says it is possible to route.
Regards,
Bragadeesh
Bragadeesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Abhishekpandey,
There shouldn't be any problem with routing the PWM signal to the pin 3.7. Are you getting any routing error in PSoC Creator? Is the project building successfully?
Even the datasheet says it is possible to route.
Regards,
Bragadeesh
Bragadeesh