- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When setting as follows, a signal of 100% duty is output from Line.
It does not seem to be compare at all, but is there a problem in operation?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is wanted.
The duty cycle in percent computes as
Period * 100 / Compare value
So when the period is equal to the compare value you expect a 100% duty cycle.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is wanted.
The duty cycle in percent computes as
Period * 100 / Compare value
So when the period is equal to the compare value you expect a 100% duty cycle.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for your answer.
Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
> It does not seem to be compare at all, but is there a problem in operation?
As far as I know of we can safely set the compare value to 0 (duty 0%)
and to the period value (duty 100%) without problem.
moto