- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello all, I am using a 11 nema stepper motor and I am trying to drive it using the DRV8834. I have never used a stepper motor in any project. can any one help me by writing an initial code to the motor to go one step to the right direction and one step to the left direction. the motor I am using is SY28STH32-0674A. I need these information to understand how stepper motors work. Thank you all
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Christiano,
Could you please check the following thread. This has example codes with which you can start.API function using Psoc4 for the drv8834 to control the stepper motor
Best Regards,
Vasanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Christiano,
Could you please check the following thread. This has example codes with which you can start.API function using Psoc4 for the drv8834 to control the stepper motor
Best Regards,
Vasanth