Control Centor for CY7C68013A-56PVXC programming

[NoAr_1540581]

Hello

After programming the program using the USB "Control Center",
Could you tell me how to check that the program was correctly rewritten by Control Centor?

Best Regards

Arai

[HirotakaT_91 · Accepted solution]

Hi,

Control Center verifies when a user programs the Firmware to FX2 EEPROM. That is, after programming, Control Center checks the programmed data and source data.

For more information, you can refer to 4.8.1 LoadEEPROM on CYUSB.NET. (it is located C:\Program Files (x86)\Cypress\EZ-USB FX3 SDK\1.3\doc\SuiteUSB)

Also, source code is available on FX3 SDK web page. Kindly refer to CyFX2Device.cs if you are interested in the detail.

Best regards,

Hirotaka Takayama

[NoAr_1540581]

了解しました

返信有難うございました