- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, BRCM experts,
I am now trying port Wiced-3.1.1 on my STM32F407 board with BCM43341, by adding my own WICED-SDK-3.1.1/platforms/MY43341/platform.c, and would like use USART1 as stdio port, but looks like it is not works. I tracked the code, it trapped into wiced_init() and never turns back. But if I use USART6 as stdio port, it works fine, my app runs without any problem. Any suggestion?
Thanks!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, jone,
I referenced to ./BCM943362WCD6/platform.c, and modified mine, it works now.
Thanks!
B. Regds
Wolfman
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Post your schematic and attached your platform files to forum!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
According your platform files.
There are missing configuration ISR and DMA ISR for usart1!
There are some EVB is used STM32F4x7 all is work well for usart1!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, jone,
I referenced to ./BCM943362WCD6/platform.c, and modified mine, it works now.
Thanks!
B. Regds
Wolfman
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Great!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you just elaborate on the settings required on UART1 so as to work as STDIO using STM32f4 Discovery board.
I cannot use UART6(Port G) as there are no pinouts on the discovery board. I tried using UART2 and it works well. But I want it to work on UART1.
Kindly give hint on the appropriate settings for platform.c
Thanks in advance.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Which pin you used as USART1 ?
if used PA9/PA10 as tx/rx USART1 , you should do some H/W modified on the trace PA9/PA10 ! Otherwise the USART1 could not output any thing!
remove the 4.7uF capacitor on the trace PA9!