Feb 20, 2019
11:35 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 20, 2019
11:35 PM
In the Cypress 45W Car Charger reference design, U4-16 (DP0) is tied to C-D- and U4-17 (DM0) to C-D+. These look reversed. Please advise.
Thanks,
Byron
Solved! Go to Solution.
1 Solution
Feb 21, 2019
01:44 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 21, 2019
01:44 AM
Hi,
It's not reversed. Pin 17 of CCG3PA should be DP/P3.0. Pin 16 should be DM0/P3.1(See datasheet). The label of the component used in this schematic is not correct.
Regards,
Eddie
2 Replies
Feb 20, 2019
11:37 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 20, 2019
11:37 PM
Added snapshot of circuit:
Feb 21, 2019
01:44 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 21, 2019
01:44 AM
Hi,
It's not reversed. Pin 17 of CCG3PA should be DP/P3.0. Pin 16 should be DM0/P3.1(See datasheet). The label of the component used in this schematic is not correct.
Regards,
Eddie