- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
One day, my rev A PSoC 6 Pioneer kit and PSoC Creator 4.2 were working fine. The next day, I became unable to debug the CM4.
The only difference that I know of between the two days was that Microsoft pushed the monthly patch to windows 10.
I tried updating the PDL to 3.1.0 and updating all of the components in the project to no effect.
I also notice that there are no breakpoints debugging the CM0+, not even the one that stops the thing at the top of main().
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please use PDL version 3.0.1 only ,PDL ver 3.1.0 is not compatible with PSoC6 rev*A.
Open PSoC Programmer 3.28 and do Erase All.
Then try to debug.
If possible please get a replacement for rev*A PSoC6.
I got same issue with rev*B PSoC6 on CY8CKIT-062, then when I did erase all using PP3.28 and Cyprogrammer available at these link, I was able to debug in PSoC Creator4.2:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please use PDL version 3.0.1 only ,PDL ver 3.1.0 is not compatible with PSoC6 rev*A.
Open PSoC Programmer 3.28 and do Erase All.
Then try to debug.
If possible please get a replacement for rev*A PSoC6.
I got same issue with rev*B PSoC6 on CY8CKIT-062, then when I did erase all using PP3.28 and Cyprogrammer available at these link, I was able to debug in PSoC Creator4.2:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Works like a champ! Thank you very much.