- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
We have some doubts about project that we are developing and we would like to know if the connection that we made between the Cypress CX3 and the USB 3.0 port is correct (see picture attached):
Best Regards,
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you provide the pcb layout file since we're not able to check from a screenshot.
Also you could refer to AN70707 which introducdes the detailed information of USB part.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you provide the pcb layout file since we're not able to check from a screenshot.
Also you could refer to AN70707 which introducdes the detailed information of USB part.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Since those files are confidential, can I send them to you via e-mail? I am not allowed to make this information avaliable on open-access places, like forums.
Best Regards,