- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
We are using BCM43907 controller, for the purpose of decoding audio signal. when it is connected with wifi signal through access point, What is the Rssi value set before the decoder looks for the next Access point? Typically the device should have the primary Access point based on best signal and neighbor APs as backup if signal or Primary drops.
Presently Optimum bandwith roaming trigger has been set.
Thanks in advance..
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I believe you are looking for the roam threshold after which your station starts searching for a new AP.
Please try the following wl command
wl roam_trigger
wl roamscan_parms
returns the roam threshold.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I believe you are looking for the roam threshold after which your station starts searching for a new AP.
Please try the following wl command
wl roam_trigger
wl roamscan_parms
returns the roam threshold.
Regards,