- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello:
I need help for my project with PSoc 4000 Pioneer kit.
I drag an I2C component onto cysch from Cypress Component Catalog. However, on cwdwr page it doesn't allow me to link the SDA/SCL to PSoC 4000 pins P3[1]/P3[0], only allow me to link to P1[3]/P1[2].
I would like to use Bridge Control Panel to debug. so I need the pin assigned to SWD debug.
Please help me to solve this problem.
Thanks.
Regards;
Chang
Solved! Go to Solution.
- Labels:
-
PSoC 4 Architecture
- Tags:
- swd debug pins
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Chang,
You can enable those pins to use other purpose in .cydwr file in PSoC Creator.
Click the [System] tap and change the Debug Select option from SWD to GPIO, then you can use P3[1]/P3[0] pins for I2C.
Please refer attached image.
Thanks,
Brandon
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Chang,
You can enable those pins to use other purpose in .cydwr file in PSoC Creator.
Click the [System] tap and change the Debug Select option from SWD to GPIO, then you can use P3[1]/P3[0] pins for I2C.
Please refer attached image.
Thanks,
Brandon
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Brandon:
Thank you very much.
Chang