Hello

[jachc_2249776]

Hello,

   We are using MB95F636K for product development ,

   I try to build a example test project in Softune IDE, connect to my target board using MB2146-70-E tool

   After build project success , Attempt to starting debug , an error prompt window appears with error message

    " *** F9411S : Cannot continue debugging due to a CR trimming value error " 

    How can I solve this problem ?

[GeonaP_26 · Accepted solution]

The CR trimming value preset for the device may be invalid, or the power supply from the user system may be insufficient.

Please restart the debug system. If the same error occurs, check the power supply of the user system, or replace the devices.