- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am working on inventek ISM43340/41 evaluation board which has STM32F4XX controller with BCM43340/41 broadcom chip.
I need information about which third party programmer supports WICED IDE. Also is there any production tool developed by broadcom
for production programming like SmartRF flash programmer developed by TI?
I believe .bin & .elf files build using WICED can be be flashed in STM32F4XX controller using third party programmer. Still question remains is how to flash .dct file using third party tools ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Reply ASAP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I will ask one of the AEs for WICED to respond.
I do not have in depth knowledge about WICED's support for third party programmers myself.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
you can do all this using JTAG and openocd (that's how WICED do with the download rule).
You can use the same openocd commands/config file for production if you have the possibility to connect JTAG pins.