Jan 23, 2019
08:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 23, 2019
08:50 PM
Hi,
I am using S25FS512S Flash device, I am using QPI mode Flash page programming after that I am trying to shift legacy SPI mode but the device is not getting exit from QPI mode, It is always responding to QPI mode transactions only.
Overall Implementation stuck at this point, If you share the sequence to bring to back to Legacy SPI mode it would helpful to us.
Thanks & Regards,
Goutham Kumar.
Labels
- Labels:
-
Serial NOR
0 Replies