1 2 Previous Next 17 Replies Latest reply on Jan 7, 2019 1:03 AM by moro_1580446 Go to original post
      • 15. Re: Programming PSOC 5 with GSM
        moro_1580446

        Thanks a lot.it is worked.i can program in psoc5 with bootloader host.now i want to replace bootloader host by gsm.and update firmware over the air.can you help me how i can do it?

        • 16. Re: Programming PSOC 5 with GSM
          urplc_1236626

          Good.

           

          There are many ways how your board can connect to your system via gsm,2G,... modem, and how you communicate with it on your host side (?). Is it TCP/IP channel or also serial UART like?

           

          • On PSoC side do not forget to configure the modem, so that it's connected and transparent, then enter bootloader which will seamlessly communicate with your host,
          • and on host side you may trick it to implement a virtual com port, unless it already behaves like this (if you're using some external device which also has UART, CDC, ... serial like port).
          • 17. Re: Programming PSOC 5 with GSM
            moro_1580446

            I am using M95(2G) quectel.psoc5 is connecting to gsm with uart.Connection network is MQTT (tcp).

            how i can programming with bootloader on gsm side?

            thank you for attention...

            1 2 Previous Next