- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everybody.I have a psoc5lp-prototype kit.it has Cy8C5888LTI-LP097 chip.I mistaked to program this board with psoc creator with a program that device selection was Cy8C5868LTI-LP039.Now i have problem with programming psoc5lp.I cant program or erase flash of psoc5lp prototype kit.how can i solved problem?
it is not solved with PSoc Programmer software too...
thanks for attention...
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Check whether the kit is in memory mode. Refer to Kitprog manual and press the reset switch for > then 5sec and watch change of kitprog LEDs.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Check whether the kit is in memory mode. Refer to Kitprog manual and press the reset switch for > then 5sec and watch change of kitprog LEDs.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thank you so much.its worked and programmed successful.