Dec 19, 2018
10:22 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 19, 2018
10:22 PM
1 Solution
Dec 20, 2018
12:06 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 20, 2018
12:06 AM
Hi,
To configure CYUSB3343 to boot from EEPROM. You just need to set Pin MODE_SEL[1:0] to 01, and connect I2C interface to EEPROM. Then the device will boot from the firmware installed in EEPROM. You can download the firmware into EEPROM by using Blaster Plus Configuration Utility in the following page:
http://www.cypress.com/documentation/software-and-drivers/blaster-plus-configuration-utility
Regrads,
Eddie
3 Replies
This widget could not be displayed.