hello,

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
PoVe_3939176
Level 2
Level 2
5 likes given First like given

how to configure EEPROM with CYUSB3343 ?

0 Likes
1 Solution
YiZ_31
Moderator
Moderator
Moderator
1000 replies posted 750 replies posted 500 replies posted

Hi,

To configure CYUSB3343 to boot from EEPROM. You just need to set Pin MODE_SEL[1:0] to 01, and connect I2C interface to EEPROM. Then the device will boot from the firmware installed in EEPROM. You can download the firmware into EEPROM by using Blaster Plus Configuration Utility in the following page:

http://www.cypress.com/documentation/software-and-drivers/blaster-plus-configuration-utility

Regrads,

Eddie

View solution in original post

0 Likes
3 Replies
YiZ_31
Moderator
Moderator
Moderator
1000 replies posted 750 replies posted 500 replies posted

Hi,

To configure CYUSB3343 to boot from EEPROM. You just need to set Pin MODE_SEL[1:0] to 01, and connect I2C interface to EEPROM. Then the device will boot from the firmware installed in EEPROM. You can download the firmware into EEPROM by using Blaster Plus Configuration Utility in the following page:

http://www.cypress.com/documentation/software-and-drivers/blaster-plus-configuration-utility

Regrads,

Eddie

0 Likes
lock attach
Attachments are accessible only for community members.

Hello Sir,

Does the Configuration between EEPROM & CYUSB3343 provides power delivery and data transfer?

0 Likes
YiZ_31
Moderator
Moderator
Moderator
1000 replies posted 750 replies posted 500 replies posted

Hi,

The configuration between EEPROM & I2C uses I2C interface. It provides data transfer with only two lines( CLK& DATA).

Regards,

Eddie.

0 Likes