- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, I am continuing my work with S6E2CC and now I tried to use CSIO from PDL 2.1.0. I wanted to communicate with my other board via SPI with S6E2CC as master at no avail-it failed to read or send. I measured with scope that clock is alive but I cannot see MOSI signal. I used csio polling example but there was no result. I upload my project below. I guess I fail to initialise something but I have no clue-maybe someone has experienced something like this?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What is the issue faced with the CSIO polling code example available in PDL 2.1.0? Please share scopeshots to understand better.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, first I am sorry for so slow response, I did not have time to take scopeshoots until today. First one is clock, second is MOSI, sending 0x05 over and over again. Baudrate is 400000 bps. I took photos quickly so cursors were not in good positions as I see myself now, but I think point is clear.