How do download a test application to the WICED Sense board? Also, what it the make command? and is there any other attach mechanism to the board?

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable


Actually, we have one additional question that goes with the above; When we follow the build instructions the following error message occurs, download failed.this version of SDK only supports download to BCM20736A1 and BCM20737A1 devices...please advise?

@

0 Likes
1 Solution
MichaelF_56
Moderator
Moderator
Moderator
250 sign-ins 25 comments on blog 10 comments on blog

You should be able to download any of the sample apps from SDK 2.X or later onto the WICED Sense Eval Kit as it is the same basic HW/SW design as the TAG3 Dev Kit.

However, the device comes up in 'Application Mode' by default, so you will need to follow the instructions here within theWICED Sense Table of Contents which explain how to take the unit apart and press the RESET button inside.

View solution in original post

0 Likes
2 Replies
MichaelF_56
Moderator
Moderator
Moderator
250 sign-ins 25 comments on blog 10 comments on blog

You should be able to download any of the sample apps from SDK 2.X or later onto the WICED Sense Eval Kit as it is the same basic HW/SW design as the TAG3 Dev Kit.

However, the device comes up in 'Application Mode' by default, so you will need to follow the instructions here within theWICED Sense Table of Contents which explain how to take the unit apart and press the RESET button inside.

0 Likes
Anonymous
Not applicable

Check the Tag3 quick start guide, basically you double click the app you want and it will download. The quick start guide will also show you how to create a target. There's no need to look at all the configuration stuff, just look at the pg 11.   WICED Smart Quick Start Guide (SDK 2.x and TAG3 Board)

You may need a recovery if you can't download the firmware, which is in the wiced sense blog that mwf_mmfae linked you

0 Likes