Problem using CY8CMBR3110 with 5VDC

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

Hello!

Since 2017 I use the CY8C3110MBR and CY8C3116MBR in our products.

Until now I used 3.3VDC for configuring and programming these chips.

However I need to use 5VDC .. It´s posible? because in the past I tried and I did have some kind of problems.

Can You help me?

best regards

0 Likes
2 Replies
LinglingG_46
Moderator
Moderator
Moderator
500 solutions authored 1000 replies posted 10 questions asked

From the MBR3 datasheet, we can find that it support the power : ■ Low-power 1.71-V to 5.5-V operation.

So it is Ok to use 5VDC.

If needed, you can describe your problem here, maybe we have ideas.

LinglingG_46
Moderator
Moderator
Moderator
500 solutions authored 1000 replies posted 10 questions asked

From the MBR3 datasheet, we can find that it support the power : ■ Low-power 1.71-V to 5.5-V operation.

So it is Ok to use 5VDC.

If needed, you can describe your problem here, maybe we have ideas.

0 Likes