- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using Cypress chip (CY8C4025AZI-S413), and the project needs to use two channels of I2C communication. However, when I dragged two I2C modules, there was an error in the compilation, as shown in the figure below. Do you have any solution? Thinks!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The chip only have two SCBs.
From the schematic, I can see you use one LIN BUS, two I2C.
The error because of the resource limitation.
If you want to use two I2C component, you need to remove the LIN.
Hope the response be helpful for you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The chip only have two SCBs.
From the schematic, I can see you use one LIN BUS, two I2C.
The error because of the resource limitation.
If you want to use two I2C component, you need to remove the LIN.
Hope the response be helpful for you.