- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello.
I'm user of miniprog3.
When I use this kit, I found some abnormal working.
So, I want to check.
Please check below, and please reply me.
- Phenomenon : When I assembly it to my laptop, laptop is turned off.
And then, debugging program is not working well. (Bridge control pannel)
For example, I connect it and power on, output voltage is 1460mV. (In normal condition, 3300mV should be measured.)
- Question : In this case, is kit damaged?
Previously, I experience same phenomenon, and I discard that kit
Is there any guide to using this kit again? (Can i repair it?)
Thank you.
Solved! Go to Solution.
- Labels:
-
PSoC 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please check this KBA :
Check Whether MiniProg3 is Working – KBA225380
If MiniProg3 has been damaged, there is no troubleshooting as such possible.
On boards where there is a single power supply for the entire board, MiniProg3 can, in some cases, supply power to the board. This supply is limited to approximately 200 mA, and is protected against excess current draw.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please check this KBA :
Check Whether MiniProg3 is Working – KBA225380
If MiniProg3 has been damaged, there is no troubleshooting as such possible.
On boards where there is a single power supply for the entire board, MiniProg3 can, in some cases, supply power to the board. This supply is limited to approximately 200 mA, and is protected against excess current draw.