- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
I am sure this question has been asked before but I am struggling to find a clear answer.
I am making a development board for a motion controller. (5LP) I would like my users to be able to debug there code in PSoC Creator. I am looking for something I can "drop" on my board. I don't want to have my users purchase a different device just to debug. I would like to keep this as low cost as possible.
Im hoping some one can point me in the right direction.
Thanks
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can use KitProg board available as part of CY8CKIT-059 PSoC 5LP Prototyping Kit as a low cost debugger.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can use KitProg board available as part of CY8CKIT-059 PSoC 5LP Prototyping Kit as a low cost debugger.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Minimum is to use a second PSoC5 programmed with the Kitprog software which is available from Cypress. Have a look into the schematics of the CY8CKIT-059 from here.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks, That is a good idea. Do you happen to know the part number?
Adrian
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Again: Follow the above link to the schematic file. Part numbers are supplied, BOM for the kit is available,too.
Bob