- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello.
I use CY96690.
We need use 128 message buffer (or 64) for CAN interface.
Is it possible to do?
Solved! Go to Solution.
- Tags:
- can interface
- cy96690
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In CY96690 DS, it mentioned 32 message buffers supported for CAN .
Best regards,
Amy Wang
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In CY96690 DS, it mentioned 32 message buffers supported for CAN .
Best regards,
Amy Wang
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
The hardware manual is for CY96600 series, which includes many different devices. For the actual number of supported message buffers of the device, please kindly refer to the "PRODUCT LINEUP" table of corresponding device datasheet.
//page 685 of MB96600 Series F2MC-16FX Hardware Manual
Best regards,
Amy Wang
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the answer.
How to make support 128 message buffer CANs ? Change microcontroller ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, need to change to MCU which can support 128 message buffer CANs.
Please note that we don't recommend legacy 16FX for any new design. If you have interest in our Auto MCU, kindly check following link for our Traveo products:
http://www.cypress.com/products/cypress-traveo-32-bit-arm-automotive-microcontrollers-mcus
Best regards,
Amy Wang