- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello!
How do I set the parameters if I want go ger Data response = "fx3 i2c" ?
I have loaded UsbI2cDmaMode to the FX3
Read Firmware ID
bmRequestType = 0xC0
bRequest = 0xB0
wValue = 0x0000
wIndex = 0x0000
wLength = 0x0008
How do I fill in the following?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi yu ming,
Refer to the screenshot below.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
How do I set the parameters if I want go ger Data response = "fx3 i2c" ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi yuming,
Please note that I have answered your question.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello!
Maybe I misunderstood,I think I would see six lettre ----"fx3 i2c" in the ?
I am wrong?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi!
I know.
Thank you for your help!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI!
The IDE gives packaged applications control center without specific code to look up. Now I'm going to use the method provided by cypress in cyapi.lib to do this transfer through EP0. How do I do that?
At the same time, if the slave device FX3 receives such instructions, I require it to be fed back through EP0, and the upper computer software receives it again, then how should the upper computer software be implemented?
Because I didn't find a similar example. Cypress provides cyapi.lib, but I didn't find any examples and don't know how to use these methods, please help?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please create a new thread for this new question.