Miniprog3 usage issue

[Regan_Yan]

Hi,

Miniprog3 can only be used as programmer, can't be changed to I2C communication mode.

How to repair it? Thanks.

[Roy_Liu]

Are you using the 5 pin connector of the Miniprog3 to do I2C communication?

What do you see in the Bridge Control panel(assuming you are using this for I2C) GUI? Not in the available port list?

[Regan_Yan]

Yes, 5 pin connector.

Failed to enumerate I2C devices when click "List" button.

[Roy_Liu]

Mostly not an issue with the Miniprog3, but the PSoC that MiniProg3 connecting with, did you try with other PSoC boards/EVK?

[Regan_Yan]

This Miniprog3 could program each PSoC normally.

If possible, I can provide this Miniprog3 to your side for testing.