CYBLE-022001-00 Mass Production

[ErLi_2535936]

Dear, Cypress Team

This is Erik Lim from UNIQUEST, Korea.

One of my customer is about to start mass production, but couldn't find Zig for CYBLE-022001-00.

Do you have answer for this ?

It's too slow with below kits.

http://www.cypress.com/documentation/development-kitsboards/cyble-022001-prog-ez-ble-module-programm...

http://www.cypress.com/documentation/development-kitsboards/cy8ckit-002-psoc-miniprog3-program-and-d...

Please help.

Thanks.

Best Regards, Erik Lim

[Roy_Liu]

Hi Erik,

What do you mean by Zig? A tool supporting open-source programming language zig?

Maybe you can check our programming partners for mass production using Cypress device

http://www.cypress.com/products/device-programmer-system-partners#tabs-0-bottom_side-2

Thanks

Roy

[ErLi_2535936]

Dear, Roy

Sorry for typo.

I'm asking about Jig for mass production.

I can't find fitting Jig for CYBLE-022001-00.

Thanks.

Best Regards, Erik Lim

[Roy_Liu · Accepted solution]

My understanding to the jig is the socket where the CYBLE-022001-00 module can fit in and connect to a programmer hardware, if so, the jig/socket is http://www.cypress.com/documentation/development-kitsboards/cyble-022001-prog-ez-ble-module-programm...​ this kit can be used for mass production programming. If you need a set of tool which can program CYBLE-022001-00 faster, you may check the partners:

http://www.cypress.com/products/device-programmer-system-partners#tabs-0-bottom_side-2