Help configuring GPOI pin as PWM and Static

I have an application where a GPIO pin must be driven with a PWM signal, but not all the time. The PWM output must be turned off sometimes.

I can get the PWM signal to work just fine. However, I cannot figure out how to get it to stop and output static high and low values. This configures the PWM:

   gpioCplxConfig.driveHighEn = CyTrue;
   gpioCplxConfig.driveLowEn = CyTrue;
   gpioCplxConfig.inputEn = CyFalse;
   gpioCplxConfig.outValue = CyFalse;
   gpioCplxConfig.intrMode = CY_U3P_GPIO_NO_INTR;
   gpioCplxConfig.pinMode = CY_U3P_GPIO_MODE_PWM;
   gpioCplxConfig.timerMode = CY_U3P_GPIO_TIMER_LOW_FREQ;
   gpioCplxConfig.timer = 0x00000000;
   gpioCplxConfig.period = 0x00010000;
   gpioCplxConfig.threshold = 0x00008000;

I think this should configure a static high on the pin but it doesn't work. The pin stays low.

   gpioCplxConfig.driveHighEn = CyTrue;
   gpioCplxConfig.driveLowEn = CyTrue;
   gpioCplxConfig.inputEn = CyFalse;
   gpioCplxConfig.outValue = CyTrue;
   gpioCplxConfig.intrMode = CY_U3P_GPIO_NO_INTR;
   gpioCplxConfig.pinMode = CY_U3P_GPIO_MODE_STATIC;
   gpioCplxConfig.timerMode = CY_U3P_GPIO_TIMER_SHUTDOWN;
   gpioCplxConfig.timer = 0x00000000;
   gpioCplxConfig.period = 0x00000000;
   gpioCplxConfig.threshold = 0x00000000;