- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I cannot get pins 3 and 4 {P5[0] and P5[1]]) to function as digital outputs on the CYBLE-022001-00 BLE Module Development Board.
Is there something special that needs to be specified for these pins to work?
I have a simple project attached that toggles a single output pin at a 50mS rate. On the Dev Board that I have, this project works on all I/O pins except P5[0] and P5[1], which are the OVTIO pins.
Thank you.
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Can you please elaborate your test scenario. We tested your project with pin set to P5.0 and P5.1 and checked the output on an oscilloscope. Both the pins are working correctly as digital output pin.
-Sayani.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Can you please elaborate your test scenario. We tested your project with pin set to P5.0 and P5.1 and checked the output on an oscilloscope. Both the pins are working correctly as digital output pin.
-Sayani.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Okay.
I have ordered a new Eval board already.
I should have it Monday.
Thank You.
Scott Coleman
949-289-1578