Does PUART-Control support power management?

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

Hello,

   I''m investigating using PUART-Control in a battery powered sensor application. Will the PUART-Control software go into a low power mode when nothing is happening? If so, will it wake up when a Master connects to it or when it receives a serial message? I looked through the code but didn't see any mention of this.

Thanks,

Derek

0 Likes
1 Solution
Anonymous
Not applicable

@kwang We put the project on hold, so no further action at this time. Thanks.

View solution in original post

0 Likes
5 Replies
BoonT_56
Employee
Employee
500 likes received 250 likes received 100 likes received

The below thread might be of interest to you.

how to reduce the power consumption when use puart ?

0 Likes
Anonymous
Not applicable

Thanks, but I was referring to the PUART-Control firmware, not just PUART in general. I guess I'll just have to test it.

0 Likes
Anonymous
Not applicable

Hello Derek,

Use GPIO to wake up when in the sleep mode and then use the PUART.

Thanks,

JT

0 Likes
Anonymous
Not applicable

dsmith still an issue?

0 Likes
Anonymous
Not applicable

@kwang We put the project on hold, so no further action at this time. Thanks.

0 Likes