Anonymous
Not applicable
Oct 18, 2018
09:39 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 18, 2018
09:39 PM
Hello everyone,
I read in the programmer's manual (section 3.6.2) that one can change the way the FX3 firmware deals with receiving a NACK from an I2C slave. For example, if I wanted to change what happened when an address match did not occur (therefore receiving a NACK), where would I find the code? Any help is much appreciated. Thanks.
Solved! Go to Solution.
1 Solution
Oct 18, 2018
10:18 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 18, 2018
10:18 PM
Hi Connor,
Please check the path
C:\Program Files (x86)\Cypress\EZ-USB FX3 SDK\1.3\firmware\fx3_sdk_1_3_3_src\fx3_sdk_1_3_3_src\sdk\firmware\src
1 Reply
Oct 18, 2018
10:18 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 18, 2018
10:18 PM
Hi Connor,
Please check the path
C:\Program Files (x86)\Cypress\EZ-USB FX3 SDK\1.3\firmware\fx3_sdk_1_3_3_src\fx3_sdk_1_3_3_src\sdk\firmware\src