- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HELLO, I am making a BLE MODULE using CY8C6336BZI-BLF03.
I asked yesterday, I have another question today
(plz check the attached file first.)
I don't use the "VTARG". So, Do not need to the attached schematic? Do I have need to use that?
If using that, can I change "VDD_NS" to "VDDR" ?
Thank you for your time and prompt response
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
There is no need to connect the VTARG as shown in the image attached.
Please note that VDD_NS should be connected to VDDD and also a 10 uF decoupling capacitor should be connected on VDD_NS.
If you are using BLE please check the connections for VDDR1, VDDR2 and VDDR3 in page number 20 of the PSoC 63 device datasheet.
http://www.cypress.com/file/385921/download
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
There is no need to connect the VTARG as shown in the image attached.
Please note that VDD_NS should be connected to VDDD and also a 10 uF decoupling capacitor should be connected on VDD_NS.
If you are using BLE please check the connections for VDDR1, VDDR2 and VDDR3 in page number 20 of the PSoC 63 device datasheet.
http://www.cypress.com/file/385921/download
Thanks
Ganesh