- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I enabled the WICED_BT_TRACE_ENABLE in application, success to build and download bin into bcm92070x_eval_b49 via J5, then press SW5 to reset, but there is no debug info output in console, just see "Error: error loading trace database file". SW2 mini switch is in default status. Here is the build log:
20:24:44 **** Build of configuration Release for project WICED-SmartReady-SDK ****
"....\\WICED-SmartReady-SDK-1.0.1\\WICED-SmartReady-SDK\\make.exe" hello_sensor-BCM920706_P49 download
--------------------------------------------------------------------------------
Patches start at 0x000D0200 (RAM address)
Patches end at 0x000DA9DC (RAM address)
Application starts at 0x0021A628 (RAM address)
Application ends at 0x0021BE6C (RAM address)
Patch size 42972 bytes
Application size 6212 bytes
------
Total RAM footprint 49184 bytes (48.0kiB)
--------------------------------------------------------------------------------
Converting CGS to HEX...
Conversion complete
Creating OTA images...
Conversion complete
OTA image footprint in NV is 57652 bytes
Detecting device...
Device found
Downloading application...
Download complete
Application running
20:25:01 Build Finished (took 17s.232ms)
Is there something i missed? or debug info cannot output via J5 ? thanks.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately, since the SmartReady/BCM20706 offering has not been released to Mass Market, support for this product is still going through our internal Help Desk system, CSP.
Also note that there is a team in your region/time zone supporting WICED Smart/SmartReady as well.
I will send you details on all of this under separate cover.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately, since the SmartReady/BCM20706 offering has not been released to Mass Market, support for this product is still going through our internal Help Desk system, CSP.
Also note that there is a team in your region/time zone supporting WICED Smart/SmartReady as well.
I will send you details on all of this under separate cover.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can set SW5 as 010100,that is turn 2 and 4 to on state.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
On the BCM2070X_EVAL_B49 board, SW5 is the yellow reset button, how to set as 010100?