- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Selecting CE222793_MotionSensor_RTOS.cywrk from the CY8CKIT-062-BLE kit options in the Start Page of Cypress' PSoC Creator 4.2 doesn't Build if the PDL selected under Tools > Options is 3.0.4.
The project builds fine if the PDL selected is 3.0.1.
I only noticed this after another user was having build issues and mentioned RTOS.
I wasn't having build issues but noticed Creator was pointing to the older 3.0.1 version of PDL even though I'd loaded the latest 3.0.4.
When I change the "PDL v3 (PSoC 6 devices) location:" link found at Tools > Options to 3.0.4 and run a Clean and Build, the following error appears:
prj.M0120:Build error: FreeRTOS.h: No such file or directory
prf.M0120:Build error: The command 'arm-non-eabi-gcc.exe' failed with exit code '1'.
Switching back to 3.0.1 all works fine.
G
Solved! Go to Solution.
- Labels:
-
ispn:39619:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Greg,
Did you check the option under "Building Settings" -> "Customizer" -> "Peripheral Driver Library" -> "RTOS"?
I guess this may be the matter.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Greg,
Did you check the option under "Building Settings" -> "Customizer" -> "Peripheral Driver Library" -> "RTOS"?
I guess this may be the matter.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you.
The RTOS selection was not checked after I selected 3.0.4. Selecting RTOS resolved my issue.
It appears when changing PDL versions in the Tools > Options > Project Management > PDL v3 (PSoC 6 devices) location: box; the RTOS selection under Project > Build Settings > <selected project> > Customizer > Peripheral Driver Library toggles. I'll make a note to check PDL version followed by a re-check of the RTOS selection if any changes were made.
G
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ID-CFI ASO にアクセスし、デバイスIDを読み出すための手順を教えてください。また、C ソースコードのサンプルはありませんか?
1)アドレス0x555に0xAAを書き込む
2)アドレス0x2AAに0x55を書き込む
3)アドレス0x555に0x90を書き込む
その後に適当な変数にアドレス0x0000の値を読み込ませたところ、
Manufacture IDは0x0001が読み出せるはずが、0x0055が格納されていました。
手順が間違っているのでしょうか?
MPN S29GL128S90TFI020
Regards -