- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello everyone,
recently at work I was tasked to write code to run three SPI buses on a PSoC board. We bought PSoC 4 L-Series Pioneer Kit (CY8CKIT-046).
I have no embedded experience at all and I am trying to get up to speed asap. So far I installed PSoC Creator 4.2 and found some examples with SPI bus:
CE224339_PSoC4_SPI_Master_DMA,
CE224463_PSoC4_SPI_Master_Interrupt,
CE224463_PSoC4_SPI_Master_Polling,
CE224463_PSoC4_SPI_Master_DMA,
DMA_SPI_PSo4.
DMA_SPI_PSo4 seems like something that I need. It builds fine, but when I try to program the device I get "No Devices Detected" error message.
The device is connected to my laptop. In fact, I can control my mouse with its sensor. I wonder if the problem is that this example is configured and built
for a different target device. When I open Device Selector I cannot find my device (CY8CKIT-046) in the list. The same happens when I am trying to create a new project:
my device ID is not in the Target Device list. Also, I do not know what to pick for the Target Module entry.
Please help! I feel lost and I have lots of pressure to perform despite my lack of experience in this field.
Thank you!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I hope you have connected the Kitprog USB port to the PC, kitprog act as Programmer /Debugger for the PSoC4200L avialble on kit.
Please check the user guide available for CY8CKIT-046 at this link:
http://www.cypress.com/documentation/development-kitsboards/cy8ckit-046-psoc-4-l-series-pioneer-kit
When you are checking for code example(CE) in PSoC Creator, please chose Device Family as PSoC4200L, then it will show all the available CE for CY8CKIT-046. DMA_SPI_PSoC4 CE can be used for CY8CKIT-046.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I hope you have connected the Kitprog USB port to the PC, kitprog act as Programmer /Debugger for the PSoC4200L avialble on kit.
Please check the user guide available for CY8CKIT-046 at this link:
http://www.cypress.com/documentation/development-kitsboards/cy8ckit-046-psoc-4-l-series-pioneer-kit
When you are checking for code example(CE) in PSoC Creator, please chose Device Family as PSoC4200L, then it will show all the available CE for CY8CKIT-046. DMA_SPI_PSoC4 CE can be used for CY8CKIT-046.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you very much!
I got my "Blinky" example working! Before I was connected to wrong(not KitProg) USB port. Lesson's learned:) More to come
Thanks!