8 Replies Latest reply on Sep 27, 2018 11:15 PM by fascc_2711286

    HCI UART not working after power cycle/reset

    fascc_2711286

      Hello,

       

      I'm developing with CYBT-343026-EVAL.

      After downloading an application to the serial flash, I transmitted WICED HCI UART commands over pc terminal(HCI UART Interface). The Traces are shown on a seperate terminal connected to PUART Interface. Everything worked fine.

       

      After power cycle the board the WICED HCI UART commands not working anymore.

      But the Traces still work.

       

      So I refered to this post BD_ADDR: Changing BCM20737 Board Address for Production .

      May this be the solution?

      And if so, where do i get the files from for my specific board?