- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I try to connect to Denebola CX3 board with JTAG Segger J-Link, but I get this message:
Error while launching command: gdb --version
CreateProcess error=2, The system cannot find the file specified
How can I solve this problem.
Avinoam
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
-Please do that On the "Debugger" tab, replace ${cross_prefix}gdb${cross_suffix} variable with arm-none-eabi-gdb.
Regards,
Anil Srinivas.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Avinoam,
Please refer "EzUsbSuite_UG.pdf. The chapter 3 of the document explain the JTAG debugging steps in detail. Please follow the same and let us know if you are still facing the issue. The document can be found in the FX3 SDK installation directory.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I did everything according to UG, and have an error message.
Avinoam Danieli
Hardware engineer
Mantis Vision
Office : 052-3331719
Mobile: +972-54-4629386
24 Imber St - Kiriat Arie
Petach Tikva 4951158
Israel
E-mail Avinoam.Danieli@Mantis-Vision.com<mailto:Avinoam.Danieli@Mantis-Vision.com>
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please try the following two ways:
1. On the "Debugger" tab, replace {cross_prefix} variable with {arm-none-eabi-}
2.On the "Debugger"tab, don't change the {cross_prefix} variable.
Regards,
Anil Srinivas.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Anil,
I did as you suggested, but have an error message.
Thank you,
Avinoam Danieli
Hardware engineer
Mantis Vision
Office : 052-3331719
Mobile: +972-54-4629386
24 Imber St - Kiriat Arie
Petach Tikva 4951158
Israel
E-mail Avinoam.Danieli@Mantis-Vision.com<mailto:Avinoam.Danieli@Mantis-Vision.com>
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
-Please do that On the "Debugger" tab, replace ${cross_prefix}gdb${cross_suffix} variable with arm-none-eabi-gdb.
Regards,
Anil Srinivas.